Kirkwood HVAC & Plumbing Services

Replaced evaporator coil with correct Lennox model 29A19 after incorrect coil was installed in June. Retrieved warranty replacement coil and completed installation, removing and disposing of incorrect unit. Verified system operation for both heating and cooling modes upon completion.

Completed comprehensive cooling system tune-up on two U10 units located in basement and attic. Performed full system diagnostics including amperage testing with clamp meter, inspected compressor motors and cooling fins, verified electrical connections, checked refrigerant levels, and cleaned condenser coils. Both units tested within normal operating parameters and are functioning properly for the cooling season.

Responded to no cooling call on 9-year-old Rheem system. Found severely clogged air filter restricting airflow, causing system to fail to operate despite thermostat clicking normally after battery replacement. Removed and replaced dirty filter with new unit, restoring proper airflow to evaporator coil and heat exchanger. System tested and confirmed operational with adequate cooling performance restored.

Responded to service call for outdoor A/C condenser unit not turning on. Upon arrival, inspected 9-year-old air conditioning system and diagnosed electrical failure preventing compressor operation. Tested capacitor and contactor, found faulty contactor preventing power delivery to compressor and condenser fan motor. Replaced defective contactor with OEM-equivalent component, verified proper voltage and amperage readings, and restored unit to full operational status with normal cooling cycle.

Completed comprehensive preventative maintenance tune-ups on two residential cooling systems, both over 10 years old and located in the backyard. Performed thorough inspection of all components including circuit boards, electrical connections, refrigerant lines, and blower assemblies. Verified proper operation of control boards, checked wire bundles and connections for secure mounting, and inspected copper refrigerant lines for integrity. Documented equipment specifications and manufacturing dates for service records, with one unit manufactured in December 2017. All systems tested and operating within normal parameters upon completion.

Completed comprehensive cooling system tune-up on 2017 residential AC unit located at ground level. Performed standard maintenance protocol including system inspection, replaced heavily soiled 16x25x1 air filter, verified electrical connections and control board operation, and confirmed all components functioning within normal parameters. Unit operating efficiently with no issues identified.

Completed electrical panel replacement in utility/mechanical room. Installed new panel with proper wire management and routing of multiple circuits, ensuring all electrical connections meet code requirements. Work area prepared with appropriate access to existing plumbing and utility systems during installation.

Replaced failed evaporator coil in second-floor air conditioning system due to no cooling condition. Removed and disposed of defective coil, installed new evaporator coil assembly, and performed complete system evacuation and refrigerant recharge. Verified proper system operation with refrigerant pressures, subcooling, and saturation temperatures within manufacturer specifications.

Completed cooling system tune-up on a 10+ year old outdoor unit located in backyard. Inspected and documented electrical components including capacitor showing age-related wear and surface oxidation. Cleared debris accumulation around unit base and verified proper drainage from condensate lines.

Completed initial assessment and photographic documentation of existing electrical panel for replacement estimate. Panel exhibits disorganized wiring with multiple circuits, bundled conductors in various colors running throughout the enclosure, and breakers arranged in dual vertical columns on the main bus bar. Documented current panel configuration, wire routing, and overall condition to provide accurate scope and pricing for new panel installation.

Responded to no cooling call on 15-year-old residential air conditioning system. Upon arrival, confirmed condenser fan motor operating at reduced speed with absent compressor operation, resulting in inadequate cooling performance. Diagnosed failed dual run capacitor as root cause of both reduced fan speed and compressor failure to start. Replaced defective capacitor with proper OEM-spec replacement, restoring full compressor and condenser fan motor operation. Verified proper amp draw on both compressor and fan motor, confirmed adequate refrigerant pressures, and tested system through complete cooling cycle with satisfactory temperature differential across evaporator coil.

Responded to service call for 10-year-old geothermal system in basement producing loud whining noise. Upon inspection, identified dirty and restrictive air filter as primary cause of abnormal system sounds and reduced airflow. Replaced existing filter with new Flanders pleated media filter to restore proper air circulation and eliminate noise issue. System tested and operating normally after filter replacement.

Completed routine preventive maintenance and tune-up on a 4-year-old Lennox cooling system. Performed comprehensive inspection of outdoor condenser unit, including examination of condenser coil fins, internal components, and refrigerant lines. Verified proper operation of all system components with unit functioning within normal parameters at time of service.

Responded to service call for HVAC system experiencing cooling issues and loss of heating function following recent furnace and thermostat installation. Upon inspection, found heavily restricted return air vent with significant accumulation of dust, lint, and fibrous debris blocking airflow through louvers and grill openings. Cleaned return air vent thoroughly to restore proper airflow, which was causing system to run continuously without achieving temperature setpoint and preventing adequate air circulation to heating elements. Verified system operation in both cooling and heating modes after cleaning, confirming proper airflow and temperature control restored to unit.

# HVAC Service Report - No Cool Responded to service call for 9-year-old ground-level unit with no cooling complaint. Upon inspection, found system operational with evidence of proper condensation formation on exterior louvers and grilles, indicating active cooling cycle and adequate heat exchange. Unit assessed and confirmed to be functioning within normal operating parameters at time of service visit.

# HVAC Maintenance - Cooling U10 Service Report Responded to service call for 16-year-old cooling system with reported constant runtime and non-functional outdoor fan. Upon arrival, performed diagnostic evaluation of the outdoor condensing unit located at ground level. Conducted electrical diagnostics using clamp meter to measure amperage draw on system components. Initial readings revealed condenser fan motor drawing 0.94 amps, indicating insufficient current flow for proper motor operation. Further testing confirmed compressor amperage at 7.34 amps while outdoor fan remained inoperative. Diagnosis determined outdoor condenser fan motor failure as primary cause of reported symptoms. Non-functional fan motor prevented adequate heat rejection from condenser coil, resulting in extended system runtime and reduced cooling efficiency. Compressor continued operating under elevated head pressure conditions due to inadequate airflow across condenser coil. Presented findings and repair reco

Performed diagnostic inspection on HVAC zoning system in response to customer complaint about noise during AC operation. Examined Honeywell Home zone control panel with active indicators for Zone 1 (green) and Zone 2 (red). Verified proper operation of Emerson thermostat displaying 72°F with cooling setpoint of 73°F in auto mode. Identified normal system operation with no issues requiring repair.

Performed super tune up service on two HVAC units under 10 years old. Conducted electrical system diagnostics with multimeter, confirming proper voltage readings within manufacturer specifications. Replaced two April Aire #213 air filters as requested to maintain optimal system performance and indoor air quality.

Conducted a complimentary electrical inspection of the customer's residential circuit breaker panel and outlet functionality. Performed diagnostic testing of electrical outlets using circuit analyzer to verify proper wiring and grounding integrity, and inspected the main panel for proper labeling and potential safety issues. Panel inspection revealed organized breakers with appropriate labeling, including dedicated circuit for refrigerator, with no immediate safety concerns identified.

Diagnosed and repaired a 10-year-old Amana furnace that was completely non-operational, resulting in no heat. Inspection revealed faulty electrical components within the control system, which were replaced to restore proper functionality and normal heating operation.