Reliable HVAC and Plumbing Services in Ellisville, MO

Completed comprehensive tune-up service on a 10-year-old ground-level AC condenser unit as part of Home Depot maintenance program. Performed thorough inspection of electrical control panel, verifying all relay contacts, integrated circuits, capacitors, and terminal block connections on the main control board; checked low-voltage control wiring and power conductor terminations for proper connections and signs of wear. Inspected and evaluated air filter condition, ensuring proper airflow through the system.

Responded to site for material retrieval from previous installation. Collected and removed remaining construction debris from basement, including PVC pipe sections, fittings, pipe insulation foam, and cardboard packaging materials left from prior service call. Materials documented photographically and removed from premises.

# HVAC Service - No Cool Responded to service call for 13-year-old residential air conditioning system blowing warm air with no cooling capability. Upon arrival, verified thermostat was set to cooling mode at 90°F setpoint but system was not producing conditioned air. Proceeded to outdoor condenser unit for diagnostic inspection. Opened electrical access panel on ground-level condenser unit and performed comprehensive visual and electrical assessment of internal components. Inspected capacitor, contactor, and associated wiring harnesses for signs of failure, damage, or degradation. Examined all wire connections, terminals, and safety devices for proper seating and continuity. Tested capacitor voltage and microfarad ratings to verify operational parameters were within manufacturer specifications. Identified failed dual-run capacitor as root cause of no-cool condition. Component showed signs of bulging and tested significantly below rated capacitance values, preventing compressor and

Completed comprehensive plumbing rough-in installation for basement bathroom renovation under permit. Relocated main water line pressure reducing valve and main shut-off valve from horizontal rafter installation to vertical riser configuration within 4" of wall, requiring removal of existing 3/4" flare x FIP connections, unsweating horizontal main, and installing new 3/4" copper 90-degree fitting with ball valve and PRV. Drilled three rafter penetrations for proper main line routing. Replaced front hose bibb and associated basement shut-off valve with new fixtures. Installed new sump pump system with check valve and rerouted 1" discharge line, securing properly to wall structure for code compliance. Added two 3/4" tee fittings with ball valves on supply lines to service new basement bathroom fixtures. Performed complete shower drain reconfiguration by removing existing first-floor shower drain piping from base to tee connection, then repipe in 2" diameter with routing above rafter lin

Completed installation of four sub-panels in residential property, mounting panels on interior walls with proper spacing and clearances per code requirements. Performed drywall modifications and patching around panel installations, with finish painting to integrate electrical infrastructure into living space.

Completed comprehensive electrical assessment of 75-year-old residential wiring system to provide estimate for full rewiring project including installation of proper grounding system and GFCI outlet protection throughout the property. Inspected existing exterior electrical service entrance, meter base, and conduit runs to evaluate current infrastructure and determine scope of work required to bring the electrical system up to current code standards for safety and functionality.

Completed seasonal cooling maintenance on two residential air conditioning systems (9-year-old unit and 15-year-old unit). Performed comprehensive tune-up procedures on both systems including inspection of evaporator coils, electrical connections, and control components. Verified proper operation of compressors, checked refrigerant levels, cleaned condenser coils, tested capacitors and contactors, inspected wiring and terminals for secure connections, and confirmed both systems are operating within manufacturer specifications. All safety controls tested and functioning correctly. Both units left in proper working condition with no deficiencies noted.

Completed cooling season tune-up maintenance on single outdoor AC unit paired with Carrier furnace system. Performed comprehensive inspection of all components, checked refrigerant levels, cleaned condenser coils, verified proper airflow through existing pleated filter and Aprilaire air purification system, and confirmed all electrical connections and controls operating within manufacturer specifications.

Responded to no cooling complaint affecting entire residence. Upon arrival, found tripped breaker at electrical panel serving outdoor AC unit. Reset breaker and verified system restored to normal operation with proper cooling throughout home.

Completed electrical estimate for multiple sub-panel installations at commercial facility. Assessed existing electrical infrastructure, including flush-mount residential-grade panel with multiple circuit breakers and Sylvania-branded panel with limited breaker occupancy. Documented panel configurations, measured dimensions, evaluated available capacity, and photographed current conditions to provide accurate material and labor requirements for proposed sub-panel additions.

Responded to no cooling complaint with indoor temperature reaching 80 degrees on a 9-year-old air conditioning system. Upon arrival, performed visual inspection of outdoor condenser unit, noting significant dirt and debris accumulation on heat exchanger coil with visible streaking and staining across horizontal fins, which was restricting proper airflow and heat transfer. Inspected indoor evaporator coil assembly in attic space, checking refrigerant line connections, filter drier, condensate drain, and electrical components. Cleaned condenser coil to remove built-up contamination and restore adequate airflow through heat exchanger. Verified proper refrigerant line connections and system operation. System restored to normal cooling capacity following coil cleaning and inspection.

Conducted on-site electrical assessment for installation of new 200-amp main service panel and 100-amp subpanel, along with five to six additional outlets in the garage. Evaluated existing exterior electrical infrastructure, including weathered meter housing showing significant rust and corrosion on mounting components and enclosure. Documented current service configuration, conduit routing, and utility connection points to develop comprehensive installation estimate for panel upgrades and garage circuit expansion.

Responded to no cooling complaint on 10+ year old ground-level condensing unit located in backyard. Upon arrival, found exterior unit heavily contaminated with accumulated dirt, dust, and debris on cabinet panels and condenser coil fins, significantly restricting airflow and heat transfer capability. Performed thorough cleaning of condenser coil and exterior surfaces to remove environmental buildup. Inspected indoor furnace unit and associated components including condensate drain system, gas line connections, and ductwork—all found in acceptable operating condition. Unit restored to proper cooling operation following maintenance procedures.

Responded to no-cooling complaint on one-year-old Lennox air conditioning unit. Upon inspection, discovered severe electrical corrosion on contactor terminals and connection points affecting unit operation. Cleaned corroded terminals, verified proper electrical connections on low-voltage control wiring and contactor assembly, and confirmed EasyStart device functionality. Tested system operation and restored cooling capacity. Documented equipment condition with photos for warranty reference.

Responded to service call for reported breaker issues on ground-level AC unit. Upon arrival, performed electrical diagnostics using clamp meter to measure amperage draw on the system, recording 25.8 amps at the outdoor condensing unit. Verified proper electrical operation and system functionality, confirming unit is operating within normal parameters.

Responded to service call for water leaking from top of air conditioning unit located in basement. Upon inspection, found excessive condensation and water accumulation on evaporator coil assembly and drain pan components. Identified clogged condensate drain line as primary cause of overflow condition. Cleared obstruction from drain line, verified proper drainage flow, and tested system operation. Unit cooling properly with condensate now draining correctly through cleared line.

Replaced failed compressor on HVAC unit serial number 1924f06602 and installed new 30-amp fuse. Recovered refrigerant from system using recovery tank, removed defective compressor, and installed replacement unit from ladder access. Documented old and new compressor serial numbers per warranty requirements for 3-year labor coverage. System tested and operational upon completion.

Responded to no cooling complaint on 10+ year old residential AC unit located on side of home. Upon arrival, found unit had been shut off by customer. Performed complete system diagnostic including electrical checks, refrigerant pressure testing, and condenser operation assessment. Identified issue preventing proper cooling operation and provided repair recommendations to restore system functionality.

Completed comprehensive cooling system tune-up on single outdoor AC unit. Performed standard maintenance protocol including inspection of internal components, electrical connections, and control board assembly. Evaluated and documented condition of 16x20x1 pleated air filter showing moderate dust accumulation. All electrical wiring, compressor components, and system controls found to be in functional operating condition.

Completed comprehensive HVAC tune-up maintenance service for Home Depot work order. Performed system inspection, replaced air filter with new pleated media filter, and inspected heat exchanger coils which showed clean condition with no debris accumulation or corrosion present.